HDPE Electrofusion Tee

Balanced Equal-Bore Branching

Where a line must fork, the tee has to split the flow without turning one arm into a bottleneck. This HDPE tee keeps an identical internal bore in all three outlets, so water or gas divides evenly, turbulence stays low, and the velocity profile settles quickly beyond the branch.

Splitting Flow Without a Sudden Drop

A constricted side outlet would throttle one arm and set up back pressure. With equal-section branches, both legs carry the medium at the same speed, which keeps the network predictable for sizing and balances demand between a loop and its take-offs.

Key features

Identical internal bore across all three outlets.

Even flow split with low turbulence at the branch.

Moulded from virgin HDPE with clean internal surfaces.

Three electrofusion sockets weld with barcode-controlled cycles.

Full SDR11 range for mains and distribution lines.

For Laterals and Looped Circuits

Equal tees suit both a simple lateral taken off a main and a looped network where equal demand is expected on each side of the branch. Consistent geometry keeps pressure recovery predictable and simplifies the hydraulic design of the whole circuit.

Applications

Looped potable water circuits with balanced demand.

Lateral take-offs along a distribution main.

Manifold headers feeding equal-size branches.

Gravity distribution where steady head matters.

Installation note

Align the three sockets in the required plane, prepare and clean each pipe end, push to the internal stops, weld every socket and allow full cooling so the branch takes load evenly once the system is filled.