view more12
Nov
HDPE Gas Fittings Price List 2026 (RMB, Per Piece)The full 2026 factory sheet in RMB: 824 prices across electrofusion, butt fusion, valves and steel-plastic transitions, the four things that move a nu
view more12
Nov
HDPE Water Supply Fittings Price List 2026 (RMB, Per Piece)The 2026 water supply sheet in RMB: 785 prices across four joining systems, why the same coupler costs less here than on the gas sheet, and how the li
view more09
Nov
NDT Inspection Methods for HDPE Welds: Ultrasonic Testing of Butt and Electro...Visual inspection stops at the surface and a pressure test passes a cold weld. Here is what each non-destructive method can prove on a PE joint, what
view more09
Nov
HDPE Welder Qualification and Operator Training for Butt Fusion and Electrofu...A certificate says the operator can make a joint while somebody is watching. Field quality is the same job with nobody watching. What the test proves,
view more09
Nov
DVS 2207 vs ISO 21307 - HDPE Butt Fusion Standard Comparison for Gas and Wate...Two standards, two different jobs. DVS 2207-1 is a procedure with a defect catalogue, a test family and a welder scheme attached; ISO 21307 is a proce
view more09
Nov
Over-Fusion in PE Pipe Welding: Thermal Degradation and Risk ControlAn oversized bead is usually the first sign of a joint that is already weaker than it looks. This covers what excess heat does to the polyethylene cha
view more09
Nov
Asymmetric Bead and Pipe Misalignment in Butt Fusion WeldingMisalignment is the defect with the cleanest parameter record and the worst outcome: every number on the sheet is correct, and the joint still carries
view more09
Nov
Material Mismatch in PE Pipe Welding: Mixed Grades and MFRThe one variable in butt fusion that the machine cannot see. MFR, crystallisation and grade determine whether two materials form a bonded section or a
view more09
Nov
Bead Cracking After Butt Fusion: Thermal Stress and CoolingThe joint is not finished when the bead closes. Most bead cracks are contraction against restraint rather than too little strength, and the finding is
view more09
Nov
Voids and Porosity in HDPE Welds: Gas, Not StrengthWater, air, thermal volatiles and oil all leave cavities in a fusion joint, and they leave different patterns. The pattern is the diagnosis, and only
view more09
Nov
Electrofusion Short Circuit and Smoke: Why Fittings BurnAn electrofusion fitting that smokes is a fitting in which the heating coil stopped being a resistor. The burn pattern identifies the cause, and any f
view more09
Nov
Butt Fusion Machine Calibration: What to Check and HowCalibration confirms the instruments, not the joints. Five variables that drift, the two ways a plate temperature is measured wrong, and the ten-minut
Send Inquiry


























